OpenShift 3.6 Support Guest Configuration: Difference between revisions
| Line 67: | Line 67: | ||
=bind DNS Server Installation= | |||
{{Error|During the next iteration, consider installing the DNS server on "in", as "in" is always on, and the load balancer also runs on "in" and it needs internal name resolution. Also make haproxy dependent on named.}} | {{Error|During the next iteration, consider installing the DNS server on "in", as "in" is always on, and the load balancer also runs on "in" and it needs internal name resolution. Also make haproxy dependent on named.}} | ||
Revision as of 04:11, 9 November 2017
Internal
Clone the Generic Template
Use the generic template as a base image and clone it, as described below.
While cloning the guest, make sure to:
- Adjust the memory and the number of virtual CPUs.
- Remove docker storage support from domain definition, but replace it with NFS storage support.
The process will produce a ocp36.ingress.
Resources
Verify the memory and the number of virtual CPUs.
Remove Docker
systemctl stop docker systemctl stop docker-storage-setup.service systemctl disable docker systemctl disable docker-storage-setup.service yum remove docker
Reset the storage, in case docker got to initialize it.
vgremove docker_vg pvremove /dev/vdb1 fdisk /dev/vdb
Prepare File System For NFS
The NFS server will serve storage for persistent volumes, metrics and logging. Build a dedicated storage device to be shared via NFS, but do not export individual volumes; the OpenShift installer will do that automatically.
Create the partition:
fdisk /dev/vdb
Command (m for help): n
Partition type:
p primary (0 primary, 0 extended, 4 free)
e extended
Select (default p): p
Partition number (1-4, default 1): 1
First sector (2048-167772159, default 2048):
Using default value 2048
Last sector, +sectors or +size{K,M,G} (2048-167772159, default 167772159):
Using default value 167772159
Partition 1 of type Linux and of size 80 GiB is set
Command (m for help): w
The partition table has been altered!
Create the filesystem:
mkfs.xfs /dev/vdb1
Follow the NFS server installation procedure, exposing it as /nfs. At this stage, make sure the storage is mounted, NFS server binaries are installed, and iptables is correctly configured to allow NFS to serve storage, and the NFS server starts at boot. The exports themselves will be configured by OpenShift.
bind DNS Server Installation
During the next iteration, consider installing the DNS server on "in", as "in" is always on, and the load balancer also runs on "in" and it needs internal name resolution. Also make haproxy dependent on named.
Consider using master SkyDNS as the only name forwarder to the support DNS server.