SELinux Operations

Internal

• SELinux

How to Find Out Whether SELinux is Enabled

getenforce

If SELinux is enabled, the command will return "Enforcing".

More details can be obtained with:

sestatus

How to Disable Enforcement

Configure:

SELINUX=disabled

in the /etc/selinux/config file then reboot the system.

Configure Permissive Mode

To set SELinux in "permissive" mode at runtime, execute:

setenforce Permissive

but this setting won't survive reboot.

Get the SELinux Security Context for a Directory

ls -lZ <dir>

SELinux Policy Boolean Operations

Listing SELinux Policy Booleans

getsebool -a

Changing SELinux Policy Booleans at Runtime

setsebool rsync_full_access=on

Without specifying anything else, the change does not survive reboot. To make the change permanent across reboots, use -P, which writes all pending values to the policy file on disk.

setsebool -P rsync_full_access=on

Troubleshooting, Diagnosing and Fixing SELinux Problems

If you have a suspicion that SELinux may be at the root of your problems, run:

tail -f /var/log/audit/audit.log

or:

sealert -a /var/log/audit/audit.log

You may get an output similar to the following one, which helps diagnose the problem:

[...]
SELinux is preventing /usr/sbin/httpd from write access on the file manager.node.nodes.lock.
[...]

Then use audit2allow to parse the audit logs and generate the SELinux policy to allow a denied operation.

grep httpd /var/log/audit/audit.log | audit2allow

#============= httpd_t ==============
allow httpd_t httpd_log_t:file write;

After you see it, you can write the policy in a file:

grep httpd /var/log/audit/audit.log | audit2allow -M mysepolicy

This will generate two files: a binary .pp file and a text .te file. The binary file thus generated can be installed as follows:

semodule -i mysepolicy.pp

The policy such applies survives a reboot.

Modify and Compile a Policy

The text (.te) file can be manually modified, compiled and installed, as follows. Assuming the text file is similar to:

module mysepolicy 1.0;

require {
        type httpd_log_t;
        type httpd_t;
        type unreserved_port_t;
        class tcp_socket name_bind;
        class dir remove_name;
        class file { write unlink };
        class udp_socket name_bind;
}

#============= httpd_t ==============
allow httpd_t httpd_log_t:dir remove_name;
allow httpd_t httpd_log_t:file unlink;
allow httpd_t httpd_log_t:file write;
allow httpd_t unreserved_port_t:udp_socket name_bind;
allow httpd_t unreserved_port_t:tcp_socket name_bind;

The policy can be compiled:

checkmodule -M -m -o mysepolicy.mod mysepolicy.te

Create the module package:

semodule_package -o  mysepolicy.pp -m mysepolicy.mod 

Install the policy:

semodule -i mysepolicy.pp

Verify that the policy was installed:

semodule -l | grep mysepolicy

Inspect and Adjust SELinux Policy Boolean Values

See:

SELinux Policy Booleans