OpenShift 3.6 Node Guest Configuration: Difference between revisions
Jump to navigation
Jump to search
(3 intermediate revisions by the same user not shown) | |||
Line 2: | Line 2: | ||
* [[OpenShift_3.6_Installation#Guest_Configuration|OpenShift 3.6 Installation]] | * [[OpenShift_3.6_Installation#Guest_Configuration|OpenShift 3.6 Installation]] | ||
For each master, infranode and node: | |||
=Clone the Generic Template= | =Clone the Generic Template= | ||
Line 21: | Line 23: | ||
=Configure Docker Storage= | =Configure Docker Storage= | ||
Repeat the template docker storage setup procedure: | |||
{{Internal|OpenShift_3.6_Generic_Guest_Template#Docker_Storage_Setup|Guest Template Docker Storage Setup}} | |||
Activate at boot: | |||
systemctl enable docker | |||
systemctl disable docker-storage-setup | |||
systemctl | |||
Latest revision as of 07:00, 9 November 2017
Internal
For each master, infranode and node:
Clone the Generic Template
Use the generic template as a base image and clone it, as described below.
While cloning the guest, make sure to:
- Adjust the memory and the number of virtual CPUs.
- Provision docker storage sized proportionally with the nature of the node.
The process will produce a ocp36.master (smaller docker storage), ocp36.infanode, ocp36.node1, ocp36.node2, etc.
Resources
Verify resources (memory, CPU).
Configure Docker Storage
Repeat the template docker storage setup procedure:
Activate at boot:
systemctl enable docker systemctl disable docker-storage-setup