Iptables Command Line Tool Examples

Internal

• iptables Command Line Tool

Base Configuration

Use the content below and overwrite the existing /etc/sysconfig/iptables.

*mangle
:PREROUTING ACCEPT 
:INPUT ACCEPT 
:FORWARD ACCEPT 
:OUTPUT ACCEPT 
:POSTROUTING ACCEPT 
COMMIT

*nat
:PREROUTING ACCEPT
:POSTROUTING ACCEPT 
:OUTPUT ACCEPT 
COMMIT

*filter

# the default INPUT chain policy is to DROP unless there's a rule that explicitly accepts the packet
:INPUT DROP 

# the default FORWARD chain policy is to DROP unless there's a rule that explicitly accepts the packet
:FORWARD DROP 

# the default OUTPUT chain policy is to ACCEPT unless there's a rule that explicitly rejects or drops the packet
:OUTPUT ACCEPT 

# anything that comes from us through the loopback interface is accepted
-A INPUT -i lo -j ACCEPT

# established connections initiated by us are accepted
-A INPUT -m state --state ESTABLISHED -j ACCEPT

# by default, we allow new SSH connections on port 22 all interfaces - we may want to change that and be more selective
-A INPUT -p tcp -m tcp --dport 22 -m state --state NEW -j ACCEPT

#
# everything else coming from outside will be dropped
#

#
# all outbound traffic is accepted
#
COMMIT

Base IPv6 Configuration

Use the content below and overwrite the existing /etc/sysconfig/ip6tables.

#
# DROP all inbound and forward traffic, allow all outbound traffic
#
*filter
:INPUT DROP [0:0]
:FORWARD DROP [0:0]
:OUTPUT ACCEPT [0:0]
COMMIT

Allow SSH Only From the Internal Network on a Non-Standard Port

Add to /etc/sysconfig/iptables. Note that all new ssh connection attempts coming on other interfaces than enp0s25 will be dropped. Make sure the enp0s25 is the internal network interface.

[...]

# allow SSH only from the internal network on a non-standard port
-A INPUT -i enp0s25 -p tcp -m tcp --dport 12345 -m state --state NEW -s 192.168.1.0/24 -j ACCEPT

[...]

Details on how to reconfigure the sshd server to listen on a non-standard port are available here: Changing the Default sshd Port. Important! sshd server reconfiguration and the firewall rule change must be done at the same time, otherwise you may lose remote ssh access between reboots.

Allow a Web Server on a Specific Interface

In /etc/sysconfig/iptables:

[...]

# allow a web server on a specific interface on both 80 and 443
-A INPUT -i enp15s0u2 -p tcp -m tcp --dport 443 -m state --state NEW -j ACCEPT
-A INPUT -i enp15s0u2 -p tcp -m tcp --dport 80 -m state --state NEW -j ACCEPT

[...]

Allow Multicast Traffic to Go Out

The standard /etc/sysconfig/iptables rule that allows all traffic out should be sufficient:

*filter
:OUTPUT ACCEPT