Linux Memory Management: Difference between revisions
(→Swap) |
(→Swap) |
||
| Line 18: | Line 18: | ||
Swap is enabled at boot by the <tt>swapon</tt> command, which is invoked by the startup scripts if swap devices are listed in [[/etc/fstab]]. | Swap is enabled at boot by the <tt>swapon</tt> command, which is invoked by the startup scripts if swap devices are listed in [[/etc/fstab]]. | ||
==Swap Info== | |||
An indication that swap is enabled is whether top displays a non-zero total swap space. | |||
==Swappinness== | ==Swappinness== | ||
Revision as of 15:29, 29 June 2017
Internal
Getting Information about Memory
Java Linux Memory
Swap
Swap is enabled at boot by the swapon command, which is invoked by the startup scripts if swap devices are listed in /etc/fstab.
Swap Info
An indication that swap is enabled is whether top displays a non-zero total swap space.
Swappinness
Swappiness is a property for the Linux kernel that changes the balance between swapping out runtime memory, as opposed to dropping pages from the system page cache. Swappiness can be set to values between 0 and 100 inclusive. A low value means the kernel will try to avoid swapping as much as possible where a higher value instead will make the kernel aggressively try to use swap space. The default value is 60, and for most desktop systems, setting it to 100 may affect the overall performance, whereas setting it lower (even 0) may improve interactivity (by decreasing response latency.)
Value vm.swappiness = 0, Strategy: The kernel will swap only to avoid an out of memory condition.
Value vm.swappiness = 60 (default)
Value vm.swappiness = 100, Strategy: The kernel will swap aggressively which may affect over all performance.