Revision as of 18:33, 24 June 2017

Internal

Updating the firmware via the LifeCycle controller implies that the LifeCycle controller has been already configured. If this is not the case, perform the following procedure: Dell LifeCycle Controller Initial Setup Procedure.

Start LifeCycle controller by pressing F10 at boot.

Home Screen -> Left-site Menu -> Firmware Update -> Launch Firmware Update.

Step 1: Select Update Repository

This procedure assumes that the LifeCycle controller is fully configured and the machine has access to Internet.

Revision as of 18:33, 24 June 2017 (view source) Ovidiu (talk \| contribs) (→‎Procedure) ← Older edit		Revision as of 18:33, 24 June 2017 (view source) Ovidiu (talk \| contribs) (→‎Procedure) Newer edit →
Line 16:		Line 16:

	This procedure assumes that the LifeCycle controller is fully configured and the machine has access to Internet.		This procedure assumes that the LifeCycle controller is fully configured and the machine has access to Internet.

	~~{{Warn\|I noticed that the LifeCycle controller network settings did not take - or did partially take - after an initial setup, so it is a good idea to check the Settings after reboot}}~~