NetworkManager Operations

From NovaOrdis Knowledge Base
Jump to navigation Jump to search

Internal

General Status

nmcli general status

Show All Connections

nmcli con[nection] show

Show All Devices

To show devices recognized by NetworkManager and their state:

nmcli dev[ice] show
nmcli dev[ice] status

Configuration Changes

Changes made with nmcli do not require a reload but do require the associated interface to be put down and then up again as follows:

nmcli dev disconnect <interface-name>
nmcli con up <interface-name>

⁠Adding a Static Ethernet Connection

nmcli connection add type ethernet con-name <connection-name> ifname <interface-name> ip4 <address> gw4 <address>

Note that a connection with the same name exists, NetworkManager will add another one, so you will end up with two connections with the same name. It is best if the existing one is either deleted, modified or edited.

Example:

mcli con del eth0
nmcli con add type ethernet con-name eth0 ifname eth0 ip4 172.30.0.4/16 gw4 172.30.0.1

Also note that the "nmcli con add" command also declare the interface as seeing the default route, irrespective of the fact a default route may already exist. To correct this behavior, modify the DEFROUTE declaration to "no" in the corresponding ifcfg-* configuration file. For more details see Linux Routing Configuration - Default Route.

Alternatively, ifcfg configuration scripts can be edited:

Linux 7 Configuring a Network Interface

Adding a Dynamic Ethernet Connection

Same as adding the static one, but without specifying the ip/gateway:

nmcli connection add type ethernet con-name <connection-name> ifname <interface-name>

Specifying a DNS Server

Set NetworkManager "dns" processing mode to "none" and "rc-manager" to "unmanaged" in the main section of NetworkManager configuration file /etc/NetworkManager/NetworkManager.conf.

[main]
...
dns=none
rc-manager=unmanaged

Then configure the DNS server(s) in /etc/resolv.conf.


Edit the Find NetworkManager configuration file and add/modify following entry in CentOS5 it is in /etc/NetworkManager/nm-system-settings.conf Or /etc/NetworkManager/system-connections/ and edit your DSL connection file :

[ipv4] method=auto dns=8.8.8.8;4.2.2.2; ignore-auto-dns=true

Disable the Network Manager

systemctl stop NetworkManager
systemctl disable NetworkManager

If it is not going to be used, it can be removed completely.

yum -y remove NetworkManager