Linux 7 Configuring a Network Interface: Difference between revisions

From NovaOrdis Knowledge Base
Jump to navigation Jump to search
Line 67: Line 67:
=Configure a Network Interface after Cloning a VM Image=
=Configure a Network Interface after Cloning a VM Image=


You want to generated a different Mac address when cloning an image, to avoid collisions.  
In general, when cloning a system, you want to generated a different Mac address when cloning an image, to avoid collisions.  


If "HWADDR" is set pointing to the old hardware address, we want to remove it from the cloned configuration file, because if it stays there, and the hardware address is not available, the interface won't start.
If "HWADDR" is set pointing to the old hardware address, we want to remove it from the cloned configuration file, because if it stays there, and the hardware address is not available, the interface won't start.

Revision as of 03:19, 4 April 2017

External

Internal

Overview

The configuration files corresponding to the network interfaces are located in /etc/sysconfig/network-scripts.

ifcfg-eth0 example:

DEVICE="eth0"
NAME="eth0"
TYPE="Ethernet"
ONBOOT="yes"
IPADDR="192.168.1.9"
NETMASK="255.255.255.0"
PREFIX="24"
GATEWAY="192.168.1.1"
DNS1="192.168.1.1"
BOOTPROTO="none"
DEFROUTE="yes"
IPV4_FAILURE_FATAL="no"
IPV6INIT="yes"
IPV6_AUTOCONF="yes"
IPV6_DEFROUTE="yes"
IPV6_FAILURE_FATAL="no"
IPV6_PEERDNS="yes"
IPV6_PEERROUTES="yes"
IPV6_PRIVACY="no"

Configuration

IPADDR

NETMASK

PREFIX

UUID

An unique ID for the interface.

A unique value can be created with uuidgen

HWADDR

Specifying the hardware or MAC address using the HWADDR directive will influence the device naming procedure.

DEVICE

Change the IP Address

DEVICE=eth0
HWADDR="08:00:27:CD:3F:EE"
IPADDR="172.20.1.3"
PREFIX="16"
NETMASK="255.255.0.0"

Configure a Network Interface after Cloning a VM Image

In general, when cloning a system, you want to generated a different Mac address when cloning an image, to avoid collisions.

If "HWADDR" is set pointing to the old hardware address, we want to remove it from the cloned configuration file, because if it stays there, and the hardware address is not available, the interface won't start.

Change the UUID

Use uuidgen.