Iptables Command Line Tool

Internal

• iptables

Overview

iptables always targets the "filter" table by default. In order to change the target table, use the -t <table-name> options.

Commands

List Rules

iptables -L -nv --line-numbers

The command list all rules in the selected chain. If no chain is selected, all chains are listed.

The command applies to the specified table ("filter" is the default). If you need to list rules from a table other than "filter", use -t (example -t nat).

The command is often used with the -n option, in order to avoid long reverse DNS lookups.

Add a Rule to the Default Table

iptables -A <chain> -i <interface> -s <source> -p <protocol> [-m <module> <module-config>] -j <target>

The rule will only be added in memory

The rule will only be added in memory and won't survive a reboot. In order to make the rule permanent TODO.

The rule will be added at the bottom of the chain

By default, the rule will be added at the bottom of the chain, after the last existent rule. This means that all existent rules will be evaluated before a packet reaches the newly added rule, so if there's a previous rule that discards the packet, the newly added rule will never be exercised. For that, you may want to consider adding the rule at a specific position in the chain.

The rule will be added to the "filter" table

The rule will be added to the "filter" table. If you need to add the rule to a different table, use -t.

-A

The chain can be one of INPUT, OUTPUT, FORWARD, PREROUTING and POSTROUTING.

Example of allowing external HTTP access on a specific interface:

iptables -A INPUT -i enp0s25 -p tcp -j ACCEPT